View Single Post
  #9 (permalink)  
Old July 25, 2009, 05:54 PM
Evylldemon's Avatar
Evylldemon Evylldemon is offline
Top Prospect
Join Date: Nov 2008
Location: Vancouver
Posts: 157

My System Specs


Originally Posted by 5ILVgeARX View Post
to set the voltage on that board.

Press del at bios boot.

go into MIB, under system voltage set DDR2 voltage control to +.300 On the right side it should say 2.1V
yeah that's what I did. Had no luck with that.

I tried turning EPP on, save, exit, now I can't get past the motherboard startup screen....

UPDATE: shorted the jumper and cleared CMOS. Boots fine but still stuck with DDR2-800 RAM. What the hell?

Last edited by Evylldemon; July 25, 2009 at 06:24 PM.
Reply With Quote