Go Back   Hardware Canucks > CASES & COOLING > Water Cooling

    
Reply
 
LinkBack Thread Tools Display Modes
  #1 (permalink)  
Old September 27, 2013, 01:15 PM
Hall Of Fame
 
Join Date: May 2011
Location: Calgary
Posts: 1,386

My System Specs

Default CHV mobo cooling question

I picked up a used mobo block recently but need to replace the thermal pads. It's the EK block. Does anyone happen to know what the thickness is supposed to be on the mosfets and the North bridge? I purchased all 3 thicknesses for now and future projects..

Thanks.
__________________
__________________________________________________ __________
"Lesson's cost money... good ones costs lots" -Tony Beets (gold rush)
__________________________________________________ __________
Mah Rig now
Mah Rig before
My stuff for sale.
Reply With Quote
  #2 (permalink)  
Old September 28, 2013, 10:15 PM
Bungwirez's Avatar
MVP
 
Join Date: Feb 2012
Location: Mississauga
Posts: 450

My System Specs

Default

I've used 0.5mm and 1mm on both mosfet and (redundantly) on RAM blocks.
Can't see any real differences...
Reply With Quote
  #3 (permalink)  
Old September 29, 2013, 06:43 AM
Hall Of Fame
 
Join Date: May 2011
Location: Calgary
Posts: 1,386

My System Specs

Default

Thx I just wanna make sure I get good contact. EK site doesn't specify.
__________________
__________________________________________________ __________
"Lesson's cost money... good ones costs lots" -Tony Beets (gold rush)
__________________________________________________ __________
Mah Rig now
Mah Rig before
My stuff for sale.
Reply With Quote
Reply


Thread Tools
Display Modes

Similar Threads
Thread Thread Starter Forum Replies Last Post
cooling question igotnacho New Builds 4 June 18, 2011 08:51 AM
Question about air cooling Mark New Builds 5 December 28, 2010 10:37 PM
Build almost decided, need opinions on mobo + cooling Peppaaro New Builds 15 October 4, 2008 12:20 AM
CPU Cooling Question SmogTown Air Cooling 9 August 24, 2008 12:40 PM
Question on Cooling lcdguy Water Cooling 25 June 17, 2007 08:31 PM