Hardware Canucks

Hardware Canucks (http://www.hardwarecanucks.com/forum/)
-   Water Cooling (http://www.hardwarecanucks.com/forum/water-cooling/)
-   -   Question about Fittings (http://www.hardwarecanucks.com/forum/water-cooling/54569-question-about-fittings.html)

Overclocking.ca June 7, 2012 12:18 PM

Question about Fittings
 
Can the fittings in this Bay Res/Pump be replaced with compression fittings?

XSPC Dual 5.25 Reservoir for One Laing D5 Single Loop XSPC Dual 5.25 Reservoir for One Laing D5 Single Loop [XSPC-DBSL-1D5] - $58.99 : DazMode PC Watercooling Gear, Canadian Best PC Watercooling and Modding Store

Thanks.

lowfat June 7, 2012 12:30 PM

Any standard G1/4 fitting will work. They are enough apart to room to fit bigger fittings.

Overclocking.ca June 7, 2012 12:39 PM

Thanks for the info.

sswilson June 7, 2012 01:29 PM

If you're going to use compression fittings on a "plastic" thread use care to ensure that you're not over torquing the barbs when you tighten the compression part onto the tubing.

Overclocking.ca June 7, 2012 02:00 PM

Thanks for the tip Steve, I am guessing finger tight should suffice.

sswilson June 7, 2012 02:11 PM

Yep fingertight with some form of grip to ensure the best torque (I've got rubber coated mechanics gloves for a good grip) ... the tip is from personal experience.... ;)

Overclocking.ca June 7, 2012 02:43 PM

I read your worklog and you had some great tips in there. After many years I have decided to dive into water cooling. I do currently have an Antec 920 kit but I want to get my feet wet with a custom loop. I don't think I am going to water cool my graphics card just the 2600K I recently bought.

I will putting this setup in the Corsair Vengeance C70 case.

This is what I was thinking for a setup so far.

RayStorm CPU WaterBlock (Intel)
Slim High Density Dual 120mm Radiator XSPC EX240
XSPC Dual 5.25" Reservoir for One Laing D5 Single Loop
Scythe Gentle Typhoon 1850RPM 59CFM @ 28db Fans
Feser Tube UV Hose - 3/8" ID - 1/2" OD - SKY BLUE/UV Blue
Various Bitspower 3/8"ID - 1/2"OD compression fittings

Fluid: Distilled Water
DazMode Protector


All times are GMT -7. The time now is 01:31 PM.