Hardware Canucks

Hardware Canucks (http://www.hardwarecanucks.com/forum/)
-   Water Cooling (http://www.hardwarecanucks.com/forum/water-cooling/)
-   -   System pics (http://www.hardwarecanucks.com/forum/water-cooling/52503-system-pics.html)

drkCrix March 16, 2012 10:25 PM

System pics








Dazmode March 18, 2012 09:10 AM

Looks like you have IceDragon liquid here...

drkCrix March 18, 2012 01:13 PM

You bet, works and looks great :thumb:

lowfat March 18, 2012 01:17 PM

Why aren't you using clear tubing to show it off?

drkCrix March 18, 2012 01:35 PM

I think when I pull the system apart to paint I may switch to clear tubbing ( I already want to pull it apart, the 1 Enzo fitting is bugging me, I was 1 90 degree BP elbow short )

bundymania March 18, 2012 03:58 PM

I wanna see some pics with 1-2 Leds in the raystorm :clap:

drkCrix March 18, 2012 04:00 PM

That will be tough as I updated the hold down to the Alu version, I do wish the BP Ram freezer had a place for some 3mm leds

bundymania March 18, 2012 04:13 PM

You can use a little plexy piece and make a hole on each side for 3mm leds. Then attach it on the ram block with some glue. With this method, you donīt have any holes directly in the nice block. i made it like this some years ago with an EK GPU block:


drkCrix March 18, 2012 05:15 PM

I will give that a go, do you have a pic of it in the light with the LED off?

drkCrix April 14, 2012 09:59 AM

Made a few changes (clear tubing, QDCs), gone are the 6950s and in there place are a pair of 7950s (1000/1575) Just need the EK back plates to finish it off

All times are GMT -7. The time now is 07:27 AM.