H60 fan screws

[jtktam]

Hi guys..

so I got the H60 in silverstone TJ08-e in a pull only config

I want to add a second for a push-pull..

does anybody know what size screws I need to install the second fan?

-joe

[Silent_Avenger]

If it's the same as the H100 as I assume it would be you'll be looking for #6-32 x 1 1/4" machine screws if you're using standard fans. Of course you'll need longer screws if you are running thicker than usual fans and shorter for thinner fans.

[dandelioneater]

Corsair has the screw length on their website in the cooling faq section

The screw thread and length are 6 x 32 x 1 1/4"
#6 machine thread, 32 TPI (threads per inch), 1.25 inches in length.
http://en.wikipedia.org/wiki/Screw#U...hread_Standard

[jtktam]

Thanks guys!

I guess the next question would be, is there enough room to mount a second in push-pull on the h60?

-joe

[techman95]

yep plenty of room to mount two fans. the rad is the same thickness as the h100 and you can easily do a push pull on that.

[jtktam]

mounted the second fan.. ended up jacking two screws from the back fan and installing them on the front fan

temps at 100% drop by 5-8c and returns to idle temp much faster

-joe

[supaflyx3]

It seems i may be a little late, but what i did with my H50 in push pull is use 2 screws on each fan so i didn't have to get more screws.

[jtktam]

Originally Posted by supaflyx3

It seems i may be a little late, but what i did with my H50 in push pull is use 2 screws on each fan so i didn't have to get more screws.

yeah, that's what I did.. but when I have time I will get more screws just in case..

wonder if home depot or crappy tire have these screws?

-joe

[Torezen]

Is there a significant improvment by adding the second fan?

[Pabz0r545]

Wow that is quite the temp difference. When I had a push pull on mine it only dropped by 1 or 2 degrees.

Home depot does in fact sell them but they only offer the silver ones last time I checked. :(
Crappy tire should carry them too.