Go Back   Hardware Canucks > CASES & COOLING > Water Cooling

LinkBack Thread Tools Display Modes
  #11 (permalink)  
Old October 23, 2010, 08:10 PM
lowfat's Avatar
Join Date: Feb 2007
Location: Grande Prairie, AB
Posts: 8,934

My System Specs


Originally Posted by CTA View Post
i would like to use normal barb...

but if i have no choices then i will get one 45 degree fitting... since http://www.swiftnets.com/assets/imag...ns-800x656.gif show that 1" distance between center of holes... so no room for 3/4 (sory i mean 3/4" od... not 5/8" od) tubing :\
I was suggesting the rotary to your other question about the pump and radiator.

2 1/2ID barbs w/ 5/8OD tubing will fit on the microres without a doubt.
The Crippled God WIP
Queen of Dreams WIP
Big Lian Li
Forever Alone Complete
Reply With Quote
  #12 (permalink)  
Old October 23, 2010, 08:20 PM
CTA's Avatar
CTA CTA is offline
Hall Of Fame
Join Date: Jul 2008
Location: langley (vancouver) bc canada
Posts: 2,244

omg... just realize... i use wrong command at autocad ... it should be diameter... not radius... sorry my bad mistake...

NEW: customize case, XFX 750W, i7 4770k, supreme hf, GA-Z87X-OC Force, 16gb gskill ripjaws 2133mhz , xfx hd6950 CF. 128gb intel 520, wd blue and toshiba 1tb, mcp355 + EK-XRES , 2x ar697, 2x PXM360, 12x AC F12 fans, 12 x shroud, STT 123W fan filter. 2442.88CDN
OLD: customize case, hx100, i7 920, supreme hf, x58 sabertooth, 3gbx2 ram of ripjaws, xfx hd6950 CF. vertex 2 60gb, seagate and hitachi 1tb, dual mcp355 with ek rex v2, 2x koolance ar697, 2x mcr320, 6x zm-f3 fans.
Reply With Quote

Thread Tools
Display Modes

Similar Threads
Thread Thread Starter Forum Replies Last Post
tubing Ken_C Water Cooling 3 January 10, 2010 11:26 AM
[WTB] 1/4"id tubing kyle_L Buy/Sell & Trade 1 October 19, 2009 04:50 AM
[WTB] 7/16 ID 5/8 OD Tubing enaberif Buy/Sell & Trade 5 September 27, 2009 07:32 AM
Smallest ID of tubing enaberif Water Cooling 5 September 26, 2009 04:43 PM
Tubing, tubing... what to choose? Dazmode Water Cooling 16 June 23, 2009 02:32 PM