Go Back   Hardware Canucks > CASES & COOLING > Water Cooling

LinkBack Thread Tools Display Modes
  #11 (permalink)  
Old July 22, 2010, 04:47 PM
Join Date: Jun 2010
Location: Winnipeg
Posts: 33

My System Specs


Originally Posted by miggs78 View Post
+1 for Primochill tubing, very good tubing really, I think it's better than Tygon too.

+1 on Distilled Water only, especially if you get Primochill tubing, some sources say primochill tubing have pre-applied biocide inside the tube..

I know the bling bling factor is important, but honestly when your side panel is closed, who's gonna look inside really, and then you also need UV fans/or a uv cold cathode tube, which is extra cost to really see a UV effect, personally I much rather spend my cash on some real good radiator/case fans, then to spend on some expensive UV fans that are gonna suck on a radiator.

I plan on going with the fesser colored tubes, and just disstilled water.

As far as UV fans - I wont be using any. I'll be buying LED strips (UV) from here and wiring them up to a spare molex since they run off 12v. Currently have 2 4.7" orange ones in my base right now

- Also, these things are amazing and fully waterproof, I originally had them in my car but took them out, when I first got them I stuck them in a bottle of water (while turned on) and left it for 24hrs - these things are magnificent, so I plan to put the orange ones in my reservoir to get a nice light show in there.
Reply With Quote

Thread Tools
Display Modes

Similar Threads
Thread Thread Starter Forum Replies Last Post
Need advice for a first time/extravagent WC setup. GT_Forthelulz Water Cooling 3 May 17, 2010 02:58 PM
First time watercooling, setup OK? TALON Water Cooling 3 August 1, 2009 01:46 PM
[WTT] My LGA775 DDR3 setup for your AM2+/AM3 setup Realityshift Buy/Sell & Trade 2 April 12, 2009 05:17 PM
Help with First WC setup... time sensitive, it's for christmas! fynd Water Cooling 19 December 22, 2008 08:55 PM
Antec 900 fail WC log (First-time WCer) jaszypoo Case Mods, Worklog & Gallery 5 December 17, 2008 05:43 PM