Go Back   Hardware Canucks > CASES & COOLING > Water Cooling

LinkBack Thread Tools Display Modes
  #11 (permalink)  
Old October 11, 2010, 05:43 PM
ottoyu34's Avatar
Top Prospect
Join Date: Aug 2008
Location: Toronto, On
Posts: 236

My System Specs


you measure from the top of the mounting plate to the top of the screw.

ruler or calipers would work.
Reply With Quote
  #12 (permalink)  
Old October 11, 2010, 07:45 PM
JD's Avatar
JD JD is online now
Join Date: Jul 2007
Location: Toronto, ON
Posts: 8,244

My System Specs


Originally Posted by chriskwarren View Post
The '200N' pressure instruction; seems that you can use calipers to measure the distance to get proper pressure (19.6mm). Did you use calipers or just tightened by hand and judged that way? If you measured, where exactly did you measure it from?
I did all that measuring BS the first time around, and it was fine. Second time I didn't and just put it until it was all nice and snug (using the provided allen key). Temperatures are still the same, so whatever. No harm done.
Reply With Quote
  #13 (permalink)  
Old October 11, 2010, 09:21 PM
KaptCrunch's Avatar
Hall Of Fame
Join Date: Feb 2008
Location: Ontario
Posts: 3,837

i didn't use the red or nylon washers to mount my HK3 no flexing MB for studs floated through holes in MB

oh the 200n referrs to 200 newtons = Pounds-Force 45lbs on WB surface

Last edited by KaptCrunch; October 11, 2010 at 09:26 PM.
Reply With Quote

Thread Tools
Display Modes

Similar Threads
Thread Thread Starter Forum Replies Last Post
[FS] Thermochill, Heatkiller, UN, Koolance, Bitspower mhw100 Buy/Sell & Trade 13 February 28, 2010 08:25 PM
Heatkiller 3.0 Apollo4g Water Cooling 88 January 30, 2010 04:21 AM
Heatkiller D5 Pump Top Technokat Water Cooling 7 January 18, 2010 07:07 PM
Heatkiller + Backplate JD Water Cooling 5 January 3, 2010 08:12 PM
Today, I've become a believer with Heatkiller rev 3.0 ontariotl Water Cooling 40 September 8, 2009 06:32 AM