Hardware Canucks

Hardware Canucks (http://www.hardwarecanucks.com/forum/)
-   Water Cooling (http://www.hardwarecanucks.com/forum/water-cooling/)
-   -   i5 water temps (http://www.hardwarecanucks.com/forum/water-cooling/27346-i5-water-temps.html)

vaughn77 January 3, 2010 10:21 AM

i5 water temps
 
i feel my temps are abit high im geting 30 to 35 doing nothing and when useing occt 65 to 70 im useing a gtz cpu block and pa 120.3 rad i5 at 4gz 1.33 vcore

i would like to know if these temps are ok and if not what it should be at

Arinoth January 3, 2010 10:24 AM

Where is the radiator located?

vaughn77 January 3, 2010 10:37 AM

out side of the case on the back , sliver stone raven

MarkOne January 3, 2010 11:12 AM

I get less than 65'C with a 212+ with 4 Ghz and 1,32 volts , what is your room temp ?

vaughn77 January 3, 2010 11:36 AM

20 to 22 could it be the fans im useing i have them in push pull , 45cfm

sigel January 3, 2010 12:35 PM

High Temps
 
Always double check if your block is seated properly, when temps don't seem right. A caliper helps to determine if each nut is tightened evenly. Those temps seem kinda ok to me although i would expect slightly lower load temps from a 120.3 rad.

vaughn77 January 3, 2010 12:45 PM

well thats just on linepacking the other cpu test on occt never gets much over 60 , 53 to 60 but still it seems like alot of ppl with air are doing around the same or better, i have checked the block a few times now. i also used thermaltake coolant 1000 , maybe i should have used water ?

MarkOne January 3, 2010 12:53 PM

are you sure you don't invert the outlet and inlet, on the gtz

gingerbee January 3, 2010 12:54 PM

ambient temps and barometric pressure matters.

vaughn77 January 3, 2010 01:00 PM

lol i had to think about that for a sec , i have it set right , you dont think the fans i have might be to weak ? yate loon 1200rpm 45cfm 24 db that and the thermaltake coolant is really all i can think of.


All times are GMT -7. The time now is 05:17 PM.