Go Back   Hardware Canucks > CASES & COOLING > Water Cooling

    
Reply
 
LinkBack Thread Tools Display Modes
  #1 (permalink)  
Old July 12, 2009, 12:12 PM
Shadowmeph's Avatar
Hall Of Fame
F@H
 
Join Date: Oct 2007
Posts: 3,348

My System Specs

Default Should I have my dualk bay res full to the top?

I am wondering if I should fill my dangerden dual bay res to the top or how far should I have it filled to?
Reply With Quote
  #2 (permalink)  
Old July 15, 2009, 09:25 PM
Top Prospect
 
Join Date: Mar 2009
Location: Montréal
Posts: 143

My System Specs

Default re

Hi

If you have a pump in it, fill it until you have covered by 1 to 2 cm above the pump inlet.


If you don't have a pump in it, simply fill it until you are above the tank inlet/outlet. Again 1 to 2 cm above should be enough.

Feel free to fill it as you wish, but depending where it is located in your loop, don't put to much coolant in it. The more coolant you put in, the more pressure it gonna do to lower WC component.

I hope it help ^^
Reply With Quote
  #3 (permalink)  
Old July 15, 2009, 10:01 PM
MpG's Avatar
MpG MpG is offline
Hall Of Fame
 
Join Date: Aug 2007
Location: Kitchener, ON
Posts: 3,143
Default

The most important thing is that the outlet is completely underwater, to ensure that only water goes back into the loop. If the inlet is also underwater, this makes it harder to air to mix with the water coming in, and is also a good thing. But don't fill the reservoir to the very top, since the level will rise and fall depending on whether the pump is running, and the temperature of the system.
__________________
i7 2600K | ASUS Maximus IV GENE-Z | 580GTX | Corsair DDR3-2133
Reply With Quote
Reply


Thread Tools
Display Modes

Similar Threads
Thread Thread Starter Forum Replies Last Post
I bought a DD dual bay res and drilled a second intake hole not sure how to thread it Shadowmeph Water Cooling 15 May 21, 2009 10:37 AM
50 Million! Top 20 PPD! Top 100 overall! zlojack HardwareCanucks F@H Team 46 May 4, 2009 12:42 PM
Fitting for top of micro-res V1 Sniper Water Cooling 6 December 6, 2008 03:12 PM
DD Dual bay res back in stock! Sniper Water Cooling 3 November 21, 2008 10:42 AM
XSPC Top and 150M Res with Thermochill Review cryostage Member Reviews 4 June 13, 2008 02:49 PM