Go Back   Hardware Canucks > CASES & COOLING > Water Cooling
Reload this Page Internal rad for Antec Twelve Hundred
Register Sweepstakes VB Image Host Members List LAN Calendar Search Today's Posts Mark Forums Read

       
Reply
 
LinkBack Thread Tools Display Modes
  #1 (permalink)  
Old September 30, 2008, 10:15 PM
Rookie
  
Join Date: Jul 2008
Location: Burnaby, BC
Posts: 48
Default Internal rad for Antec Twelve Hundred
Anyone which which dual 120mm rad lines up with the 1200 so I can mount it internally?
Digg this Post!Share on Twitter
Reply With Quote
  #2 (permalink)  
Old September 30, 2008, 10:30 PM
MpG's Avatar
MpG MpG is offline
Hall Of Fame
  
Join Date: Aug 2007
Location: Kitchener, ON
Posts: 3,116

My System Specs

Default
Haven't seen it done yet. But if you measure the distance between the inside fan holes (center to center), you may get a hint. If they're 15mm apart, Swiftech, HWL and the newer Feser rads will line up. 17mm, the original feser rads will line up. 23-ish mm, and a TC might line up.

But that's all assuming there's enough clearance around the edges for the rad body and the fittings. Again, haven't seen it done yet.
__________________


Reply With Quote
  #3 (permalink)  
Old September 30, 2008, 10:43 PM
Cptn Vortex's Avatar
Hall Of Fame
F@H
  
Join Date: May 2007
Location: Vancouver
Posts: 3,616
Default
Just mount a MCR220 to the top fan. you dont need to line them up perfectly
__________________
The Vortex H20

Coolermaster ATCS 840 w Window panel
EVGA SR-2 Classified
2 x Xeon L5639 Hexcore CPUs, 3.2GHZ
EVGA GTX 580 - 940/2115
24GB Mushkin Blackline 1600MHZ 9-9-9-24 1.5v
Asus Xonar Essence STX
OCZ Z-Series GOLD 850W
2 x 90GB Corsair Force SSD RAID0
Sharp 32" Aquos 1080p
Benq W500 Pojector.

Watercooling:
2 x EK Supreme HF, MCR320+Gelid Silent 12 Push/Pull, DD Pump, EK Multioption 100ml Res, XSPC GTX 580 FC block, EK Coolstream XT 220 RAD Gelid Wings Push - CM R4s Pull.
Reply With Quote
Reply

 

« Previous Thread | Next Thread »
Thread Tools
Display Modes
Linear Mode Linear Mode