Go Back   Hardware Canucks > PC BUILDERS & TWEAKERS CORNER > Troubleshooting

    
Reply
 
LinkBack Thread Tools Display Modes
  #1 (permalink)  
Old August 2, 2008, 04:28 PM
Rapid-X's Avatar
MVP
 
Join Date: May 2007
Location: Ajax
Posts: 332

My System Specs

Default finally but WaiT HELP

ok got my rig up and running but when i install my dwa-130 wireless n usb adapter it freezes every say 10-15 mins of the system being on. i tried it without the adapter installed and it went for about 20 mins the longest and then froze. could it be my PSU ?? The setup is in my sig only running one harddrive the maxtor
Reply With Quote
  #2 (permalink)  
Old August 9, 2008, 01:12 AM
Top Prospect
 
Join Date: Jun 2008
Location: Brisbane, Australia
Posts: 223
Default

What temps are you getting? Use something like |MG| EVEREST Free Edition 2.20 and post a screenshot of "Sensors", tht should give us a good indication.
__________________
Q6600@3.15Ghz|CNPS9500|GA-EP45T Extreme|GSkill 2GB 1333MHz|Sapphire 4850|OZC GameXtreme 700|XP64
Reply With Quote
  #3 (permalink)  
Old August 9, 2008, 07:41 PM
JD's Avatar
JD JD is offline
Moderator
F@H
 
Join Date: Jul 2007
Location: Toronto, ON
Posts: 6,955

My System Specs

Default

Probably bad drivers. My laptop would freeze up after a while when I put in a D-Link card. I found other drivers that supported the chipset used in the card and now my laptop doesn't freeze up.

So it's probably a similar issue for you. Try other drivers listed on the D-Link site, otherwise you'll have to search around.
Reply With Quote
Reply


Thread Tools
Display Modes