Go Back   Hardware Canucks > PC BUILDERS & TWEAKERS CORNER > Troubleshooting

    
Reply
 
LinkBack Thread Tools Display Modes
  #1 (permalink)  
Old March 13, 2014, 01:03 AM
Trial Member
 
Join Date: Mar 2014
Posts: 1
Default Wiring SPST LED pushbutton 6-pins

Hi,

I recently bought this push button from ebay.
I would like to wire it between a 12V powersupply and a 12V 2-pin fan as I have attached to my WRT54GL router.

I am quite confused on how to do this properly. I have only experience with wiring 3-pin Rocker Switches.

Thanks in advanced :)


Reply With Quote
  #2 (permalink)  
Old April 8, 2014, 01:53 PM
KaptCrunch's Avatar
Hall Of Fame
 
Join Date: Feb 2008
Location: Ontario
Posts: 2,922
Default

need to know if led light is 3.3v or 5v for to use correct resistor, if not use one will burn out led, possible melt switch

other is what your total load for switch......watts or amps don't exceed switch rating 50mA, if need to use a relay



strange diagram states SPST
Attached Images
 

Last edited by KaptCrunch; April 8, 2014 at 02:09 PM.
Reply With Quote
Reply


Thread Tools
Display Modes

Similar Threads
Thread Thread Starter Forum Replies Last Post
Waterpump wiring r0k0 Case Mods, Worklog & Gallery 9 December 4, 2012 03:54 PM
Wiring Woes! New to Wiring. Need Help!!! JoeOnePack Troubleshooting 10 June 8, 2012 02:30 AM
Wiring Phones lcdguy Networking 5 August 24, 2011 07:26 AM
How Many Pins? kendallcschm Power Supplies 22 July 7, 2010 09:44 PM
Wiring up case johnnyuterus Guides & How-to's 10 June 4, 2009 06:27 PM