Go Back   Hardware Canucks > PC BUILDERS & TWEAKERS CORNER > Troubleshooting

    
Reply
 
LinkBack Thread Tools Display Modes
  #1 (permalink)  
Old September 11, 2007, 08:30 PM
enaberif's Avatar
Hall Of Fame
 
Join Date: Dec 2006
Location: Calgahree, AB
Posts: 10,582
Default Motherboard or Power Supply

Alright so I just picked up a Antec Quattro 850w power supply and paired it with a Asus P5N32-E SLI board and it seems when I hookup the 8 pin EPS my power supply goes into what seems almost a overload situation.

The power supply will triple in heat and the fan on the rear becomes super obnoxious, but if I hook up the 4 pin the power supply is perfectly fine.

My question is... power supply or board? The board is also out 0.03v when overclocking and to get 1.4v I need to set it to 1.43 which to me is within spec.
Reply With Quote
  #2 (permalink)  
Old September 12, 2007, 05:37 AM
Hall Of Fame
F@H
 
Join Date: Jan 2007
Location: Scarborough
Posts: 1,437

My System Specs

Default

P5N32 series,ugghh, mine used to whine from time to time. It might be heavy power supplies that cause it. I'm not sure. My tagan did it at the beginning, but after a while, it seemed to calm down. It's still working OK and no more whining.
__________________


EBAY(http://myworld.ebay.ca/scott0639)
Reply With Quote
Reply


Thread Tools
Display Modes

Similar Threads
Thread Thread Starter Forum Replies Last Post
Is my power supply enough? Shepherd Power Supplies 3 August 19, 2007 09:32 PM
Power Supply Requirements enaberif Power Supplies 9 August 1, 2007 02:22 PM
Power Supply Calculator Shadowed Power Supplies 14 April 15, 2007 10:05 AM