Go Back   Hardware Canucks > PC BUILDERS & TWEAKERS CORNER > Troubleshooting

    
Reply
 
LinkBack Thread Tools Display Modes
  #1 (permalink)  
Old December 10, 2008, 07:23 PM
Rookie
 
Join Date: Oct 2008
Posts: 14
Default Mobo mounting

I just bought the gigabyte x58 and i was just wondering if i should put washers on both sides of the mounting holes to be safe? Even though the holes are metallized.. >.<
Reply With Quote
  #2 (permalink)  
Old December 10, 2008, 07:28 PM
Soultribunal's Avatar
Moderator
F@H
 
Join Date: Dec 2008
Location: Mississauga
Posts: 8,066

My System Specs

Default

The Brass Standoffs should be fine without washers. I have always put them on the Screw side however.
This is just the way I do, other people might have a better idea, but its never given me any problems.

Regards,
ST
__________________




"We know not why he calls for us, only that when he does we must answer" - DMP 2009

"Dear Iceberg, I am sorry to hear about global warming. Karma is a bitch. Signed - Titanic"

I would rather believe and find god doesn't exist than to not believe and find that he does.

www.realhardwarereviews.com
Reply With Quote
  #3 (permalink)  
Old December 10, 2008, 07:50 PM
Rookie
 
Join Date: Oct 2008
Posts: 14
Default

ok thanks, but the bottom looks like it doesn't get enough clearance for the motherboard to not poke into the case.. so ill put washers on the bottom. ;D thanks guys
Reply With Quote
Reply


Thread Tools
Display Modes

Similar Threads
Thread Thread Starter Forum Replies Last Post
Anyone need a dtek 1366 mounting kit? sheepdogexpress Water Cooling 1 December 6, 2008 04:39 AM
Top Mounting a Rad miggs78 Water Cooling 9 September 23, 2008 09:54 AM
Need help mounting a fan Kentalish Air Cooling 5 July 20, 2008 03:31 AM
120.3 mounting question iv:xx Water Cooling 4 July 10, 2008 04:03 PM
FS-s939 X2-3800, OCZ ram, Ac Freezer 64 Pro, ASRock mobo, DFI mobo, Asus mobo..more stoanee Buy/Sell & Trade 14 June 7, 2008 06:24 PM