Hardware Canucks

Hardware Canucks (http://www.hardwarecanucks.com/forum/)
-   RAM (http://www.hardwarecanucks.com/forum/ram/)
-   -   Little problem... (http://www.hardwarecanucks.com/forum/ram/7417-little-problem.html)

AnthraxAdrian May 26, 2008 07:18 AM

Little problem...
 
I've been getting a lot of BSOD often, and I think they are memory related.

When I bootup my pc, I see 4gb registered, but at 5-5-5-31 timings... It used to be 5-5-5-15

And it says is should be at 4-5-4-15..

This is the memory I have(4 sticks)
OCZ Dual Channel EL Platinum XTC 2048MB PC6400 DDR2 800MHz Memory (2 x 1024MB) OCZ2P8002GK at TigerDirect.com

DK2 May 26, 2008 07:25 AM

if bios settings are on auto, try and set using manual....?

rom0n June 1, 2008 07:05 PM

Try to reset the CMOS. Mem86 test it. Then go manual and input the desired latencies.

Boldeagle June 24, 2008 03:19 AM

What app is telling you 5-5-5-31, EVEREST used to tell me 5-5-5-2 when my timings were at 5-5-5-18, CPU-z would report it correctly. Now my timings are at 4-4-4-12 and both apps report the same results. EVEREST would give false readings for some reason!

JD June 24, 2008 11:59 AM

You most likely need to increase the RAM voltage and possibly the NB voltage as since your running 4x1GB.

zlojack June 24, 2008 01:06 PM

What hardware are you running?

ipaine June 24, 2008 02:38 PM

I actually have been having similar problems with my rig. Was getting a bunch of BSOD's and ended up bringing everything back down to stock and even removing 2 of my 4GB. Then after a failed reboot I shut it right down and gave it a few minutes, turned it on and my memory also gave timings of 5-5-5-31. And that was on the initial BIOS screen. It stayed like that until I went back into the bios and set the timings manually. Since then it seems to have been good.

So once I get a chance, (maybe tonight) I will try with the 4GB again, and this time increase the voltage a bit to see if that helps. But as for the incorrect timings, once I but it back to manual it reports it fine.

3.0charlie June 24, 2008 02:41 PM

4 sticks put a lot of stress on the NB - you have to adjust voltages (Vmch and Vram) accordingly.


All times are GMT -7. The time now is 11:29 AM.