Help with Dominator Platinum 2133Mhz
Hello guys, i need your help.
I have 8X4GB of DDR3 Corsair Platinum 2133Mhz ram for a total of 32Gb. Memtest was fine when testing them last time.
When im using all of thoses sticks, my pc crash.
Set voltage at 1.65v and still crashing.
So, ill remove 4 sticks and now windows is booting only when ram is running at 1333Mhz.
WHen i set the ram in the bios at 2133Mhz, the pc is crashing again after few mins of use. (like 10 or 15 mins of use)
I need help and suggestions, im tired of thoses problems i got in the last month.
here config if needed
Asus P9X79 Workstation
Evga GTX 690
Fresh new install of windows 7 with all updates.
Thanks for your help
I'd try bumping the vdram to 1.67ish and see if that helps
G777: Im gonna try at 1.67 v
Enaberif: I have 8 sticks of 4GB
Ooops right.. even worse!
Do a quick timing check for (1t) vice (2t) . Most mem these days seems to be rated for 2t and the boards often default to 1t for some strange reason. Could be that it'll run 2 / 4 sticks @ 1t without complaining, but fail miserably once you've got a full board of them.
Enaberif : :shok:
Sswilson: PC was running at 2T... ill do a test at 1T to see.
Right now, im running at 1833Mhz and no problems until now. Im gonna try at full speed between 1T in few mins
I was to tired last night to start playing with setting. I will continue tonight
What are the timings on the memory? As wilson stated 1t will be more difficult to run with that much memory.
|All times are GMT -7. The time now is 07:46 AM.|