Hardware Canucks

Hardware Canucks (http://www.hardwarecanucks.com/forum/)
-   Networking (http://www.hardwarecanucks.com/forum/networking/)
-   -   Cisco DPC3825 (Rogers) Static LAN ip config (http://www.hardwarecanucks.com/forum/networking/59637-cisco-dpc3825-rogers-static-lan-ip-config.html)

biggyk February 10, 2013 06:31 PM

Cisco DPC3825 (Rogers) Static LAN ip config
 
Had it working before but I forgot what the addresses were since I reinstalled windows. Just trying to change the ip on my static. I thought it was

192.168.0.xxx
dns 255.255.255.0
gateway: 192.168.0.1
DNS 192.168.0.1

Thanks

Keywork February 11, 2013 08:51 PM

I'm assuming you meant this:

IP: 192.168.0.xxx
Mask: 255.255.255.0
gateway: 192.168.0.1
DNS: 192.168.0.1

Or you can just turn on DHCP, see what it gives you, and then return to static when you know what to base it off of.

biggyk February 11, 2013 09:04 PM

Exactly but it doesn't work. It is in dhcp right now. I want to change it because I already have other devices setup for a specific ip.

enaberif February 11, 2013 09:23 PM

Quote:

Originally Posted by biggyk (Post 689773)
Had it working before but I forgot what the addresses were since I reinstalled windows. Just trying to change the ip on my static. I thought it was

192.168.0.xxx
dns 255.255.255.0
gateway: 192.168.0.1
DNS 192.168.0.1

Thanks

What are you trying to do exactly?

why do you have two dns for?

What Keywork said is correct. But you don't need to worry about dns.

biggyk February 12, 2013 11:17 AM

first dns should be mask my bad.

im just trying to change the ip address that my desktop is using.

Keywork February 12, 2013 01:07 PM

Are you saying that the IP you want to use is already in use by something else or...?

biggyk February 12, 2013 01:12 PM

No it isnt but when i enter the addresses on my desktop the internet no longer works. This used to work before I formatted.

Keywork February 12, 2013 01:19 PM

If you are putting in the correct values, there should be no issue. Care to post a screenshot of you inputting the values?

biggyk February 12, 2013 01:25 PM

sure, here you go.
http://i117.photobucket.com/albums/o...ps251c1d14.jpg

Keywork February 12, 2013 01:50 PM

And to confirm, when you press OK, and then OK again, you lose internet connectivity? If so, try the following:

- before changing the IP, open up a CMD prompt, and ping 192.168.0.150. Confirm that it is in fact not in use.
- Make the changes, and then proceed to disable, and then re-enable the interface.
- Possibly unplug and plug back in the ethernet cable.

Keep us posted!


All times are GMT -7. The time now is 05:46 AM.