Hardware Canucks

Hardware Canucks (http://www.hardwarecanucks.com/forum/)
-   Guides & How-to's (http://www.hardwarecanucks.com/forum/guides-how-tos/)
-   -   L.F. How To Guide Sites for GA-P35-DS3R (http://www.hardwarecanucks.com/forum/guides-how-tos/7956-l-f-how-guide-sites-ga-p35-ds3r.html)

sircuster June 14, 2008 07:25 AM

L.F. How To Guide Sites for GA-P35-DS3R
 
Removed

3.0charlie June 14, 2008 08:55 AM

Can you be more precise on exactly what you are looking for, or what is the problem?

3.0charlie June 16, 2008 06:07 PM

I don't believe the DS3R allows for hot-swaps.
Use the purple SATA ports if you wish to run your Raptors in Raid 0.
If you are not oc'ing, leave the ram setting per SPD.
Unless you have a PCI-e SATA controller, all SATA components will be driven by the Intel Controller.

3.0charlie June 17, 2008 01:47 PM

I don't see why you couldn't use 2x IDE drives on the IDE channel. Just set-up the drive jumpers properly (Master vs. Slave) and connect the Master drive at the end connector, while the Slave drive can be connected at the mid connector.

sircuster June 17, 2008 03:18 PM

Quote:

Originally Posted by 3.0charlie (Post 62625)
I don't see why you couldn't use 2x IDE drives on the IDE channel. Just set-up the drive jumpers properly (Master vs. Slave) and connect the Master drive at the end connector, while the Slave drive can be connected at the mid connector.

Aren't the IDE Connectors part of the purple sata connectors. In other words, if using Purple as raido, then no IDE.

3.0charlie June 17, 2008 03:21 PM

Nope; the IDE and SATA controllers are totally independent. Where did you read that?


All times are GMT -7. The time now is 09:47 AM.