Go Back   Hardware Canucks > PC BUILDERS & TWEAKERS CORNER > Guides & How-to's

LinkBack Thread Tools Display Modes
  #1 (permalink)  
Old August 30, 2009, 05:52 PM
WolfBane's Avatar
Hall Of Fame
Join Date: Jun 2008
Location: new bruinswick
Posts: 1,179

My System Specs

Talking lighting a window

hey guys i have a silly question ?
ok i am having my TJ09 window lazer etched and i want to know how do i light it so that the whole etching lights up?
i have a 12 inch blue cathode in my box now at the bottom and i think it will light up part of it .
but my question is is there a way to lightly drill small holes and install some blue LED bulbs so that it will all light up the same and only the etcdhing?
Remember... Four boxes keep us free: the soap box, the ballot box, the jury box, and the cartridge box.
Reply With Quote
  #2 (permalink)  
Old October 12, 2009, 05:05 PM
Join Date: Oct 2009
Location: Toronto
Posts: 33

How thick is the window? If it is thick enough you can make some small 3mm led holes and wire them up.
Reply With Quote
  #3 (permalink)  
Old October 12, 2009, 05:36 PM
Sushi Warrior's Avatar
Hall Of Fame
Join Date: Aug 2009
Location: Grimsby, Ontario
Posts: 1,620

My System Specs


Put 3/5mm LED's around the perimeter of the plexi and it should just light up the etching.
||EK Supreme LT Nickel||MCP355/EK X-TOPV2||EK150 M-O res||MCR220/White||NZXT FN120RB/FN140RB||
Project|Oroborous by NZXT and MNPC
Reply With Quote

Thread Tools
Display Modes

Similar Threads
Thread Thread Starter Forum Replies Last Post
How to install a window? Overclocker~4.1 Guides & How-to's 29 October 13, 2009 03:56 PM
Lighting case mod any good without led fans? dosmond Cases 3 June 27, 2009 05:40 PM
HElp about window XP v0maru Troubleshooting 2 February 14, 2009 07:38 AM
office window CTA O/S's, Drivers & General Software 0 October 20, 2008 12:10 AM
Window Appliqués BALISTX Cases 5 October 15, 2007 08:21 PM