Go Back   Hardware Canucks > PC BUILDERS & TWEAKERS CORNER > Guides & How-to's

    
Reply
 
LinkBack Thread Tools Display Modes
  #11 (permalink)  
Old March 6, 2009, 06:43 PM
KaptCrunch's Avatar
Hall Of Fame
 
Join Date: Feb 2008
Location: Ontario
Posts: 2,955
Default

note use ESD safe type soldering iron on MB, for bare wires is ok as long not hooked to any ic's if need to solder MB bring it up to heat then un-plug it from 120v source

the reason is that i've killed a laptop re-soldering cmos battery. after i check earth to tip my multi-meter showed 27vac, i guess element had a voltage leak
Attached Images
 

Last edited by KaptCrunch; March 9, 2009 at 06:40 AM.
Reply With Quote
Reply


Thread Tools
Display Modes

Similar Threads
Thread Thread Starter Forum Replies Last Post
dvd trouble part 2 t0m Storage 16 March 11, 2009 06:42 PM
[FS] Partial Part-Out jetOne Buy/Sell & Trade 11 December 27, 2008 12:35 PM
Odd part requirement Exmortis Cases 0 December 3, 2008 08:37 PM
Upgrade Part II Phaddie New Builds 45 November 4, 2008 05:18 PM
OCZ part #OCZ2G8002GK ebdoradz RAM 3 June 3, 2007 07:49 AM