Case Pics

[Babrbarossa]

Wanna throw together a little component/setting list in a sig for us voyeurs?

Edit: Just noticed the FS post for that gorgeous case... what are you upgrading to?

[cdn_Madrach]

Originally Posted by Supergrover

Did you buy it new? If so then it's not stainless steel. Even if it's not it could be conductive so keep that in mind.

The PSU was purchased new. The cables actually have a thick clear rubber sleeving over top(very stiff:( ) Thanks for the heads up though Supergrover.

[cdn_Madrach]

I also like the Lian-Li cases. They are so clean(neat) looking inside. Some day I'll have one set up with WC. Hopefully:) Nice setups BTW.

[SKYMTL]

Alot of blood (I'm not kidding, you can still make out some of the smears), sweat and tears went into fitting this inside a Sonata case....




I know, nothing special....

[b1lk1]

I suck at cable management but here's the latest pic of my "beast". This is just a super cheapo CanadaComputers case that has been massively modded.

[SKYMTL]

Is that 1/2" tubing? If so, remind me to avoid that size....it is HUGE.

[enaberif]

Not my case, but wish it was... built this a few days back.

Antec Titan 550 Server Case
Asus Workstation Board
nvidia 7600s x 4 :)

[Babrbarossa]

You could live in there...

[SHaCK]

Originally Posted by SKYMTL

Is that 1/2" tubing? If so, remind me to avoid that size....it is HUGE.

?? 1/2" ID looks so freaking good! What, do you prefer 1/4" ?

b1lk1, is there a 2nd fan on the other side of the rad ?

[b1lk1]

The front rad has a fan on both sides, but the heatercore hanging off the back only has the 1 fan. That is actually 7/16" ID tubing and it is the smallest I'd feel comfortable running. Full load I keep my CPU under40C and my GPU has yet to see 35C even highly overclocked to 575MHz core (stock is 450). I have a MCW60-T GPU block (built in TEC) that I am prepping to use on a 7900GTX I am in the middle of RMAing so I am gonna move the single 120MM heatercore on the back to the inside of th case replacing the front rad and I am gonna hang a dual 120MM heatercore off the back of the case where the current 120MM heatercore is. As you can tell, I cannot stand air cooling and I feel it is not worth the effort to get mediocre results using air compared to the excellent results I get from water. Although I do admit that the amount of setup time does make water more of a hobby than requirement.