Go Back   Hardware Canucks > HARDWARE > CPU's and Motherboards

    
Reply
 
LinkBack Thread Tools Display Modes
  #21 (permalink)  
Old November 10, 2009, 06:45 PM
Rookie
F@H
 
Join Date: Apr 2009
Location: Calgary, AB
Posts: 29
Default

Quote:
Originally Posted by Arinoth View Post
As long as none of the pins are bent it should be fine as it was not operating during its travel from point a to the floor.
Reply With Quote
  #22 (permalink)  
Old November 10, 2009, 06:58 PM
martin_metal_88's Avatar
Hall Of Fame
F@H
 
Join Date: Apr 2009
Location: Quebec City
Posts: 4,175

My System Specs

Default

Quote:
Originally Posted by zoob View Post
Most likely no problems.

At any rate, Intel's RMA process is A++++, would recommend again!
I've RMA'd about three CPUs with Intel and every time it was very very very quick turnaround (granted I two-day ship it to Intel).

Well eveyone have story to story XD I had only 2 expereicen with intel services. 1 for a CPU, 1 for a board. The CPU went flawlessly. They cross ship a new CPU in 48 hour with pre-paid boxing. But for the board, it have been 4 week of complain and rage with the intel support...It always depend on time and the guys you get
__________________
Ask for more

Martin_metal_88
Colenzo : See system spec!

Odysseus : I7 860 @ 3.6Ghz || GA P55-UD5 || G.skill Ripjaws F3-16000 2000Mhz 2X2GB || Coolermaster ATCS 840 || Silverstone Strider plus 850W || WD 640 black - WD 1TB green - Samsung F3 2TB || MSI 5670 1GB Cyclone ||Coolermaster Hyper 212 + ||

Reply With Quote
Reply


Thread Tools
Display Modes

Similar Threads
Thread Thread Starter Forum Replies Last Post
Desk or Floor? Signal2Noise Cases 38 September 17, 2009 06:49 PM
Killing floor issue ToXic Troubleshooting 9 August 31, 2009 06:01 PM
Killing Floor cmac79 Gaming 10 May 17, 2009 10:00 AM
ECS X58 Motherboard Ad Campaign - This will put you on the floor laughing Linus CPU's and Motherboards 9 November 21, 2008 09:11 AM
Prices of LCD panels fall through the floor: Inquirer Babrbarossa Display Units 1 March 16, 2007 01:39 PM