Go Back   Hardware Canucks > HARDWARE > CPU's and Motherboards

    
Reply
 
LinkBack Thread Tools Display Modes
  #1 (permalink)  
Old November 23, 2008, 09:28 PM
arekieh's Avatar
Allstar
F@H
 
Join Date: Oct 2008
Location: Edmonton
Posts: 819
Default Are my temps fine?

Hey guys,
Kinda worried about my temps. i just remounted and they dropped a bit, but still too hi for my liking, These are uncured temps though.

Its running at Idle: 36, Load 62.
This is at 1.48v
Im using AS5 w/TRUE 120 w/2x Antec Tricool

I remounted 3x all temps were within 1c all 3 mounts
__________________
Mobo: Asus P6T Deluxe | CPU: i7 940 | Ram: 3x2 GB | HSF: CM V8 | GPU: HD 6950 | PSU: PCP&C 750W | ]HDD: WD 500gb x3, 120GB Vertex 2 | Case: Antec 1200 | Monitor: 3x Asus VE247H | OS: Win7 Ultimate x64
My Trading Rep:
HWC
OCN
Heat
Ebay

Reply With Quote
  #2 (permalink)  
Old November 23, 2008, 09:30 PM
"Quote This..."
F@H
 
Join Date: Nov 2007
Location: Hell
Posts: 3,833
Default

that's about right. the e6750 is not a 45nm chip right?
Reply With Quote
  #3 (permalink)  
Old November 23, 2008, 09:38 PM
arekieh's Avatar
Allstar
F@H
 
Join Date: Oct 2008
Location: Edmonton
Posts: 819
Default

Nope. Its a 65nm

I just dropped my voltage abit, im at 1.45 now. 1.48 is my 3.8ghz voltage. Anyways, my idle temps are wierdly higher??? sitting at 40c. i was a bit impatient and didnt wait that long though. My load temps are now 62..... same range.... even though voltage dropped 0.3.

Then again, the heat register right below my desk is running full blast. thats probably a cuase as well
__________________
Mobo: Asus P6T Deluxe | CPU: i7 940 | Ram: 3x2 GB | HSF: CM V8 | GPU: HD 6950 | PSU: PCP&C 750W | ]HDD: WD 500gb x3, 120GB Vertex 2 | Case: Antec 1200 | Monitor: 3x Asus VE247H | OS: Win7 Ultimate x64
My Trading Rep:
HWC
OCN
Heat
Ebay


Last edited by arekieh; November 23, 2008 at 09:43 PM.
Reply With Quote
Reply


Thread Tools
Display Modes