Go Back   Hardware Canucks > CASES & COOLING > Cases

    
Reply
 
LinkBack Thread Tools Display Modes
  #11 (permalink)  
Old December 29, 2012, 02:22 PM
Allstar
 
Join Date: Oct 2012
Posts: 701

My System Specs

Default

Yep,its way better for those reasons,just be careful of what materials you have on the table,make sure there is space between the case and the table,if the case is not high,make sure that the air can be sucked,not only because of dust...

Anyway i think it's better to have the computer on a table and not on the ground,because you filters will be quickly dusty if you put your computer on the ground.
Reply With Quote
  #12 (permalink)  
Old January 3, 2013, 01:50 AM
Rookie
 
Join Date: Dec 2011
Location: Brandon, MB
Posts: 30
Default

Just to add for bottom mounted psu the bulk of the cables will be closer to the motherboard tray side so it would be closer to cable management cut outs therefore easier to manage.

The case being on top of table also lessens instances for the case to get dinged or scuffed or scratched :)
Reply With Quote
Reply


Thread Tools
Display Modes

Similar Threads
Thread Thread Starter Forum Replies Last Post
"BF3.3" Level 10 GT Case Mod is "Locked and Loaded" Mnpctech Cases 2 July 12, 2012 01:18 PM
How do i know if my "Drive Controller" is running in "AHCI mode"? Teo3201 Storage 2 October 8, 2011 10:54 PM
MSN 2011 Causing "hard" power off? (Resolved, wasn't MSN related... ;) ) sswilson Troubleshooting 5 January 5, 2011 05:25 PM
3d Vision goes from "gimmick" to "ubiquitous" The RealRollo Video Cards 28 October 21, 2010 04:55 PM
Stupid "puts PC into low power state..." is crunked donimo O/S's, Drivers & General Software 11 August 23, 2008 05:23 AM