Hardware Canucks

Hardware Canucks (http://www.hardwarecanucks.com/forum/)
-   Cases (http://www.hardwarecanucks.com/forum/cases/)
-   -   Mountain Mods Ascension (http://www.hardwarecanucks.com/forum/cases/56154-mountain-mods-ascension.html)

TRI-MIX August 17, 2012 03:52 PM

Mountain Mods Ascension
 
Looking at getting this case NEXT week . Is anyone Using this case ? And what kind off loop are you running . I have two 560 rads to go in with a heatkiller cpu block.
Would like your input on layout

Thanks TRI-MIX

scruff August 17, 2012 04:05 PM

My budy and I just bought 2 of these but the extended model . You shouldn't have any problem putting most anything you want in it . We are installing 3 quad 120mm and 1 240x120mm rads in them . I am going to be running quad 680's ,full motherboard and ram blocks on 4 loops . (Rampage 4 , 64gb dominator ram , 3690x proc) So far I like the case , lots and lots of room. Good luck with your purchase :punk::clap:

Liu Kang September 25, 2012 04:13 AM

I have the extended version with the pedestal... it's a monster of a case, but you will need to custom build a panel for 2x560 (no default panel can support 2 of them). I got my front panel custom built, and I got the case within a few weeks from ordering. No complaints.

As for layout, just make sure you can drain your loops easily. It's not the kind of case you can lift or tilt to drain...


All times are GMT -7. The time now is 06:09 AM.