Go Back   Hardware Canucks > CASES & COOLING > Cases

    
Reply
 
LinkBack Thread Tools Display Modes
  #11 (permalink)  
Old August 17, 2009, 10:56 AM
Supergrover's Avatar
Hall Of Fame
F@H
 
Join Date: Dec 2006
Location: Okanagan Falls, British Columbia
Posts: 4,252

My System Specs

Default

Quote:
Originally Posted by bovine.baron View Post
When you're cutting, don't press on the Dremel, its' weight and the weight of your hand is enough to get the cutting disc to do its' job. If you press on it, you'll wear it out way quicker and might even make it shatter. And this applies to trying anything new really, but relax and remember not to tense up. I always see people working with their shoulders up to their ears. Yikes, that can't be comfortable!
Buy the reinforced discs, they are way harder to shatter than the cheapo discs.

As for the "sharp" edges see if you can pick up some small C-Channel moulding, I used to recommend Per-PC's for this but not anymore.
__________________
R.I.P.

Quote:
Originally Posted by 3.0charlie View Post
My knuckles are bleeding from fishing through walls a new CAT6 network cable... I found fresh, untapped electrical outlets...
"It's all in the Reflexes"-Jack Burton
Reply With Quote
Reply


Thread Tools
Display Modes

Similar Threads
Thread Thread Starter Forum Replies Last Post
FS: Antec 900 Jon_di2 Buy/Sell & Trade 3 September 13, 2008 04:19 PM
Antec 900 and WC LooseCannon Water Cooling 13 March 16, 2008 04:44 PM
Antec 900? richuwo11 Cases 41 January 13, 2008 07:26 PM
Watercooling the Antec 900 JD Water Cooling 44 December 10, 2007 09:13 AM
Watercooling an antec 900 moditir Water Cooling 11 July 15, 2007 09:02 AM