Go Back   Hardware Canucks > CASES & COOLING > Cases

    
Reply
 
LinkBack Thread Tools Display Modes
  #1 (permalink)  
Old January 2, 2009, 12:57 AM
chouchou's Avatar
MVP
F@H
 
Join Date: Oct 2008
Location: Vancouver
Posts: 444
Default Workin on a 900, got a couple questions

Hey all
workin on some CB management for a buddy of mine
he's runnin an AM2+, and it looks like ass right now so ima try and fix it up for him.

Just have a couple questions regarding clearence between the motherboard tray and the side panel, is it enough for a 24 pin cable? i wanna try and route shit behind the case..
Also, is there a chuck adapter for drills that allow for 1 1/4 inch bits to fit into it? posisbly? =\

thanks all
Reply With Quote
  #2 (permalink)  
Old January 2, 2009, 05:47 AM
MVP
 
Join Date: Aug 2007
Location: Windsor, Ontario, Canada
Posts: 305
Default

best I can offer is this... when I had the case I never ran the cables behind, so I am not too sure, but a million people have so I would assume it will fit. And about the drill, I dont think so, at least I have never seen one, unless your using a Demming drill where its a small shank and a big drill bit. If its for the holes you want to cut in (just a guess) can you use a hole saw?

A Positive Look at the Antec Nine Hundred (900) Case - XtremeSystems Forums
__________________
i2600k sandy bridge @ 3.4ghz/ 2x 8800 GTX KO ACS3 PCI-E 630MHZ 768MB 2.0GHZ SLI'd / Raptor 74GB / Antec 1200 Hundred Gaming Case / G.Skill Ripjaws ddr3 1600 cl 8-8-8-24 - 8gigs / evga z68 SLI MOBO / Samsung DVD+RW / Corsair ax850 PSU / 24" Samsung CinkMaster

Cooling:
Swiftech Dual rad
Swiftech Single rad
Swiftech Micro Res
Swiftech Apogee GT Cpu block
Feser One Red Fluid
Reply With Quote
  #3 (permalink)  
Old January 2, 2009, 04:48 PM
chouchou's Avatar
MVP
F@H
 
Join Date: Oct 2008
Location: Vancouver
Posts: 444
Default

haha yeah i have the hole saw
except that the arbor is bigger than 3/8 =\
Reply With Quote
Reply


Thread Tools
Display Modes

Similar Threads
Thread Thread Starter Forum Replies Last Post
A couple of questions about Vid card differences Shadowmeph Video Cards 4 December 2, 2008 12:11 PM
Couple questions Sniper Water Cooling 10 May 23, 2008 10:51 AM
OC'ing e3110, a couple questions... biff Overclocking, Tweaking and Benchmarking 11 March 27, 2008 10:11 AM
RivaTuner,couple of quick questions.....Hardware Monitoring Canadianguy Video Cards 2 December 8, 2007 07:00 PM
Couple questions nasrott CPU's and Motherboards 4 July 12, 2007 02:46 AM