Hardware Canucks

Hardware Canucks (http://www.hardwarecanucks.com/forum/)
-   Cases (http://www.hardwarecanucks.com/forum/cases/)
-   -   Workin on a 900, got a couple questions (http://www.hardwarecanucks.com/forum/cases/13434-workin-900-got-couple-questions.html)

chouchou January 2, 2009 12:57 AM

Workin on a 900, got a couple questions
 
Hey all
workin on some CB management for a buddy of mine
he's runnin an AM2+, and it looks like ass right now so ima try and fix it up for him.

Just have a couple questions regarding clearence between the motherboard tray and the side panel, is it enough for a 24 pin cable? i wanna try and route shit behind the case..
Also, is there a chuck adapter for drills that allow for 1 1/4 inch bits to fit into it? posisbly? =\

thanks all

frosty January 2, 2009 05:47 AM

best I can offer is this... when I had the case I never ran the cables behind, so I am not too sure, but a million people have so I would assume it will fit. And about the drill, I dont think so, at least I have never seen one, unless your using a Demming drill where its a small shank and a big drill bit. If its for the holes you want to cut in (just a guess) can you use a hole saw?

A Positive Look at the Antec Nine Hundred (900) Case - XtremeSystems Forums

chouchou January 2, 2009 04:48 PM

haha yeah i have the hole saw
except that the arbor is bigger than 3/8 =\


All times are GMT -7. The time now is 02:06 PM.