Go Back   Hardware Canucks > CASES & COOLING > Cases

    
Reply
 
LinkBack Thread Tools Display Modes
  #1 (permalink)  
Old November 11, 2008, 10:02 AM
rjbarker's Avatar
Hall Of Fame
 
Join Date: Feb 2008
Location: Courtenay, B.C
Posts: 5,790

My System Specs

Default TJ09 Case n Additional 120 mm Fans

Hey guys, will be recieving my new TJ09 Case here in the next few days..I have also coming with it 3 additional Scythe Flex 120 mm 1200 RPM Fans.
Question, which would be the most efficient solution to setting up the additional Fans?
the Case stock comes with :
1 - 120 mm intake blowing directly onto GPU's
2. - 120 mm Exhaust at top rear.

I have 3 120mm to add, was thinking (as seen the same config on another Forum):
1. Additional 120 mm lower intake blowing onto HDD (in essence another Intake)
2. Additional 120mm Exhaust at top of case front portion
3. Additional 120mm Intake on top of case / back portion

this set-up would basically be 3 x 120 mm Intakes and 2 120 mm Exhaust, resulting in "Negative Pressure"...within...

Note: I'm mounting the HX 1kW right side up on the bottom so it draws cool air in from outside Case.

Thoughts would be very much appreciated.
Reply With Quote
  #2 (permalink)  
Old November 11, 2008, 10:04 AM
rjbarker's Avatar
Hall Of Fame
 
Join Date: Feb 2008
Location: Courtenay, B.C
Posts: 5,790

My System Specs

Default

Quote:
2. Additional 120mm Exhaust at top of case front portion
3. Additional 120mm Intake on top of case / back portion
I buggered this part up, should be reversed...:
1. Additional Exhaust on top of Case Back portion and
2. Additional Intake at top of Case front portion...
Sorry
Reply With Quote
Reply


Thread Tools
Display Modes