Hardware Canucks

Hardware Canucks (http://www.hardwarecanucks.com/forum/)
-   Case Mods, Worklog & Gallery (http://www.hardwarecanucks.com/forum/case-mods-worklog-gallery/)
-   -   Gallery Watercooled Corsair 350D (http://www.hardwarecanucks.com/forum/case-mods-worklog-gallery/61494-watercooled-corsair-350d.html)

mojojj June 2, 2013 07:15 PM

Watercooled Corsair 350D
 
Update: Dec. 4, 2013. It's been a while, here's an update

http://i.imgur.com/FGObnQah.jpg

http://i.imgur.com/KQrCIq3h.jpg


Original: June 2, 2013
-------------------
Transplanting the stuff from my FT03 (build log here) to a Corsair 350D.

http://i.imgur.com/Aj5WGiF.jpg

http://i.imgur.com/fYvMtwu.jpg

Not quite complete yet as I need a new 30mm thick dual rad for the top.

Pabz0r545 June 2, 2013 07:18 PM

Great build and sweeeeeeet case! I love smaller builds. I would love to see a bay reservoir in there though as it would clean it up a bunch!

lowfat June 2, 2013 07:34 PM

Are those Dazmode extensions?

mojojj June 2, 2013 07:38 PM

Quote:

Originally Posted by lowfat (Post 712873)
Are those Dazmode extensions?

Yes, they are. I haven't routed them optimally, i'll do that later.

mojojj June 2, 2013 07:40 PM

Quote:

Originally Posted by Pabz0r545 (Post 712871)
Great build and sweeeeeeet case! I love smaller builds. I would love to see a bay reservoir in there though as it would clean it up a bunch!

I'm not really a fan of the bay-reservoirs. =)

hero1 June 3, 2013 10:11 AM

Nice build man.

crazyea June 3, 2013 02:09 PM

I like this a lot. Are you going to be putting something between the two rads?

Masteroderus June 3, 2013 08:48 PM

Looks great man! I really like the d5 top / res all in one piece.

KylSp June 3, 2013 08:57 PM

Quote:

Originally Posted by mojojj (Post 712875)
I'm not really a fan of the bay-reservoirs. =)

I'm not either after owning two (452x2 & that xspc one made out of nylon, what a piece of garbage). They're horrible to bleed and can if your'e not careful are much easier to ruin a pump with a bad prime. Going back to a cylinder res when I do my haswell build.

Nice build so far, that top rad should fit perfectly.

Pabz0r545 June 3, 2013 09:45 PM

Quote:

Originally Posted by KylSp (Post 713094)
I'm not either after owning two (452x2 & that xspc one made out of nylon, what a piece of garbage). They're horrible to bleed and can if your'e not careful are much easier to ruin a pump with a bad prime. Going back to a cylinder res when I do my haswell build.

Nice build so far, that top rad should fit perfectly.

I've never understood how everyone seems to have trouble priming and bleeding their loop. I had that black nylon one and never had a single problem bleeding it.


All times are GMT -7. The time now is 07:54 AM.