Hardware Canucks

Hardware Canucks (https://www.hardwarecanucks.com/forum/)
-   Case Mods, Worklog & Gallery (https://www.hardwarecanucks.com/forum/case-mods-worklog-gallery/)
-   -   DarkVault (https://www.hardwarecanucks.com/forum/case-mods-worklog-gallery/37746-darkvault.html)

kyle_L January 4, 2012 08:44 PM

nice dude.

Silent_Avenger January 5, 2012 12:48 AM

Nice setup you have there. Btw, you have a nice view outside.

blueweb January 5, 2012 08:29 PM

:) Thanks, ya I can see Parliament Hill If I look around the patio barrier, will be nice to watch the fireworks.

Rison January 8, 2012 06:44 AM

That looks friggin sweet.

Just a note: your radiator for the Corsair is upside down. You want the tubes to be on the bottom.. reasoning is, is it will still slowly leak coolant from the system - when this happens the air bubbles will be trapped on top and it will cease to push liquid through the tubes = failure of pump.
You will want to orient the tubes either on the side, or on the bottom. Better yet, if you can mount the entire rad on the top - it's better performance as it evens out the liquid in the rad.

blueweb January 8, 2012 08:39 PM

Thx :D
Ya I would have to cut a hole on top but don't have the tools or time for that right now.
It's a sealed unit so I am not to worried about that... until it breaks I will just buy something new.
I was thinking of their dual rad model but I think the tubes would be too short to mount either at the front or behind the motherboard above the power supply...

mjbdc07 February 25, 2012 09:53 AM

very nice build, what keyboard is that?

blueweb March 10, 2012 07:34 PM

Thanks :)
It's the Alienware TactX keyboard.


All times are GMT -7. The time now is 01:26 PM.