Post your WaterCooled PC pics here thread

[matsta31]

Nice. Tight space ! what are theses radeon ?

[DTI]

Originally Posted by matsta31

Nice. Tight space ! what are theses radeon ?

Thanks... correct 3 x 5870

[JMCD]

ugh, need to sleeve another 6/8pin, it's so out of place :(

[sswilson]

New loop for my Lian-Li open testbed. I'm hoping that the extra tubing going to the WB will be allow any different motherboard to be used without having to redo the loop. 4 thumbscrews to remove the whole loop if I wish, and I've got a new EK Supreme HF WB for max compatibility.

Not sure what I think of the Fesser tubing. It's easy to work with, but feels a bit flimsy when compared to tygon.

[Jackquelegs]

Is..that...an IDE cable?

[sswilson]

Hehe..... yeah.... Still got a few IDE drives kicking around, and I see absolutely (other than asthetics) no reason not to use them on folding rigs. :)

[Jackquelegs]

Originally Posted by sswilson

Hehe..... yeah.... Still got a few IDE drives kicking around, and I see absolutely (other than asthetics) no reason not to use them on folding rigs. :)

Just curious, is there enough room to bolt the rad to the area above the DVD drive?

[sswilson]

Originally Posted by Jackquelegs

Just curious, is there enough room to bolt the rad to the area above the DVD drive?

Yes, but it's a mAtx motherboard currently installed and I wanted to be absolutely sure that any motherboard would fit. The other requirement for the loop was that I wanted to be able to remove it with a minimum of fuss, and without having to actually disassemble the loop. As it stands..... 4 thumbscrews, and removal of the WB (the tray has access from the bottom) is all that's required to return it to standard config.

[Reyzac]

Originally Posted by sswilson

Not sure what I think of the Fesser tubing. It's easy to work with, but feels a bit flimsy when compared to tygon.

I find that Feser tubing is flimsy no matter what. To me it's even flimsier than my Clearflex 60.

[Bao]

Phantom NZXT White case: