Saw your post @ ncix
Try these
FSB Strap to North Bridge: Auto
DRAM Frequency: Use Rated Speed
DRAM Command Rate: 2T
DRAM Timing Control: Manual
CAS# Latency: 4
RAS# to CAS# Delay: 4
RAS# Precharge: 4
RAS# Activate to Precharge: 12
*Use Highest Numbers First for Below*
Write Recovery Time: 6(4-6)
REF Cycle Time: 60(50-60)
Write to Read Delay: 11(9-11)
RAS# To RAS# Delay: 4(3-4)
Read to Pre Time : 6(4-6)
DRAM Static Read Control: Disabled
Transation Booster: Disabled(Enabled*)
Relax Level: 1(0-1) (0 being for more perf 1 being for more stability) (*Boost Level when TB enabled, 0 being relaxed, 1-2 being for more perf) . This setting will result in most perf gains normally, is affected by fsb, memory strap and memory speed being used
DDR2 Voltage : 1.95-2.05v (might be overvolting, best to make 2.1v max you try, which is what Dr.Memory said as rated.
Hope this gets you up and running, it should.
|