View Single Post
  #4 (permalink)  
Old September 17, 2008, 02:39 PM
encorp's Avatar
encorp encorp is offline
Hall Of Fame
F@H
 
Join Date: Apr 2008
Location: Toronto
Posts: 3,425

My System Specs

Default

Just go into your bios and set the timings and other settings to what it says on the sticker, 5-5-5-12, 500mhz x 2 = 1000.

They'll work great, I found that they can even run well on less than stock voltage, it says 2.0 to 2.1 on the sticker but I have mine at 1.95 and run them at stock timings with 533mhz (x2=1066) and benched them/tested to full stability no problems at all. I could probably push them to 1100 on the recommended voltages (2.0ish) but I've been dealing with some folding errors so I set my comp to stock till I know whats causing them; but when it's done I'm gonna push my sticks a bit and see if I can't at least get close to 1100.
__________________
DISCLAIMER: The views and opinions expressed in the immediately preceding post are those of encorp and do not reflect the views and/or opinions of family, friends, or anyone remotely associated with encorp unless explicitly stated. encorp does not make any warranty, express or implied, or assumes any liability or responsibility for the quality, factuality or use of information in the immediately preceding post.
Reply With Quote