Thread: Work in progress 3930K watercooled Colossus
View Single Post
  #17 (permalink)  
Old April 12, 2013, 02:04 PM
Astaroth's Avatar
Astaroth Astaroth is offline
Top Prospect
Join Date: Sep 2010
Posts: 170

My System Specs


Did some work today. It was held up as I waiting an eternity for my slim drive cable. Then It turns out the cable was just short enough that I needed to get a longer one. More waiting for that one. Then finally decided to put it together. I didn't bother cabling the hot swap drive. Don't think I'll use it that much to be honest. Needed it mainly for the optical & USB3.0 front panel. This is an older version of the Colossus case with the super awkward USB3.0 PCB. Not the green PCB model, but the second beige revision after that. Had to remove it to accommodate the 280mm rad. All that's left will be to wire the top panel back in. Then I won't have anything to throw money at until I snap and get a new GPU.
Attached Images
Reply With Quote