View Single Post
  #5 (permalink)  
Old March 31, 2013, 09:34 AM
Hooded's Avatar
Hooded Hooded is offline
Top Prospect
Join Date: Dec 2012
Location: Bowmanville,Ontario
Posts: 188

My System Specs


What I did with my XSPC bay res was add a long tube (2') to the res fill port so I was able to keep it open while I rocked the case around a lot to chase the larger air bubbles out. This gives the loop a breather point well above the top rad. Once bled remove the tube.

Your flow is stopping due to an air lock large enough that when your pump is set on 1, it's not pushing hard enough to move the air. Set your pump to 3 for bleeding.
Reply With Quote