View Single Post
  #2 (permalink)  
Old January 21, 2013, 07:54 AM
SlippySlappy SlippySlappy is offline
Trial Member
 
Join Date: Jan 2013
Location: Victoria
Posts: 1

My System Specs

Default

Having the same problem as you are with the 920, seems the plastic is very cheap and soft. All four of my pins just spin in their place. Found one person recommended using this plate from frozen cpu, apparently it works with the Kuhler Prolimatech LGA 1156 Megahalem Retention Mount Adapter Kit (IAK-01) - FrozenCPU.com . One thing i'm going to try tonight is you can put a screw in the back side of the pin, hold that with a screw driver while tightening the one on the CPU. Then remove the back screw. Real pain in the ass as I have to take the board out completely as i don't have rear access to two of the lower screws.

Going to send an email to antec and see what they say, they'll probably send me a new plastic plate which will have the same problem.
Reply With Quote