Thread: Dazmode News
View Single Post
  #534 (permalink)  
Old December 23, 2012, 07:20 AM
Hooded's Avatar
Hooded Hooded is offline
Top Prospect
F@H
 
Join Date: Dec 2012
Location: Bowmanville,Ontario
Posts: 169

My System Specs

Wink

You are taking the compression fitting cap off first?

Disassemble the fitting.
Tighten barb to block,res., rad etc...
Slide cap on to tube,
Then push tube on to the fittings barb.
Slide the cap down to the fitting a tighten.

If the tube seems tight to slide on to the barb then put the end of the tube in warm water for 10sec's to soften tubing a little then try to put on barb.
Hopefully this was of some help.

Last edited by Hooded; December 23, 2012 at 07:23 AM. Reason: Typo's Galore
Reply With Quote