View Single Post
  #9 (permalink)  
Old October 25, 2012, 01:29 PM
SugarJ's Avatar
SugarJ SugarJ is offline
Moderator
F@H
 
Join Date: Jan 2008
Location: Langley, BC
Posts: 6,082

My System Specs

Default

My original thought yesterday was that you were just going to remove the stop fitting and drain from there, which would spray around a bit. I'd be way more comfortable with a drain tube. I usually make mine long enough to run outside the case.

Edit: Just had a thought. The flow from the opposite port will tend to try to push into that tube rather than make an angle and go through the block. It should be ok once the loop is full, but watch your flow while filling. This is one case where I'd definitely disconnect the CPU and GPU until you know that you've got good flow through the loop. The blocks heat up fast if there's no flow, as I found out the hard way.
Reply With Quote