Thread: Completed Bitfenix Ghost WC build
View Single Post
  #15 (permalink)  
Old October 24, 2012, 02:16 PM
sswilson's Avatar
sswilson sswilson is offline
Moderator
F@H
 
Join Date: Dec 2006
Location: Moncton NB
Posts: 14,227

My System Specs

Default

One major arrival, and mostly built except for the loop which is waiting for a Rad from Dazmode (might be here by the end of the week, if not, then likely monday).




Once again, just about every part of this loop is something I picked up used through HWC. SugarJ jumped at an awesome deal on a Galaxy 680 and then made me an offer I couldn't refuse on his 580 w/ EK block.



Pretty much everything but the loop installed. Front side cable management is easy enough (although you might want to route the CPU power cable through the cut-out before installing the motherboard), but I think I might need to do a little bit of work to the back side. :)

This will be my first WC'd vid card, and in spite of SugarJ's warnings I'm kinda liking the "B" side of the vid card block as a drain port (assuming I don't install any cards below it). It's the lowest part of the loop, and if I put a container underneith it I should be able to open the two lower ports to drain.
__________________
EVGA X58 3X SLI / i7 980X / 3X 4G Mushkin Blackline Frostbite / XFX Pro 1000W / EVGA GTX 680 SC+ 2GB / Intel DC S3700 200G / WD 6401AALS / TT Lvl 10 GT
Swiftech MCP655 WC Pump / EK XT 240 Rad / 2X Scythe Ultra Kaze / EK Supreme HF / Primochill Myriad Dual Bay Res / Dell UltraSharp U2412M

Gigabyte C1007UN-D / 2X4G Gskill PC3-10700 / Pico PSU / 2.5" 750G Toshiba HDD / Mini-Box M350 / 1X 19" BenQ / 1X 17" HP
Reply With Quote