View Single Post
  #1 (permalink)  
Old September 26, 2012, 11:45 PM
geoc geoc is offline
Top Prospect
 
Join Date: Nov 2011
Posts: 180
Default Bleeding swiftech mcres v2

Well, the bug has bit me again, and I am doing a new loop for a computer that doesn't even exist (i'll buy parts for the loop later).

Right now I am having issues with the swiftech mcres v2, it seems like that all the bubbles that get pushed out get sucked right back into the pump. I have left the loop on for hours, and large bubbles are still circulating through the loop(you can see them zip by in the tubing)

There is very little flow restriction in the loop as well, so no bubbles are getting trapped in the rad or whatsoever.

I am using the 2 middle vertical holes for the nozzles, with the lower one being the outlet to pump.
Reply With Quote