View Single Post
  #27 (permalink)  
Old August 2, 2012, 10:23 PM
lowfat's Avatar
lowfat lowfat is offline
Join Date: Feb 2007
Location: Grande Prairie, AB
Posts: 8,313

My System Specs


PCB from a Koolance PMP-400. Was surprised it was the same PCB as the MCP35X.

Pulled the pump apart to make it easier to solder the PCB.


Pump actually worked afterwards....... Until this morning when I killed it again. The 12V solder pad on the PCB pulled off. So unfortunately I am back down to one working pump.

A pic of my DDC graveyard / parts. I can get most of them working again if I put the time in to fix them. But I'll have to use the DIYINHK PCBs which are loud as eff since they run 60% faster plus they don't have PWM.
Big Lian Li
Forever Alone
Reply With Quote