Thread: Completed Bitfenix Prodigy Watercooled
View Single Post
  #39 (permalink)  
Old June 27, 2012, 09:09 PM
Father Fuzzy's Avatar
Father Fuzzy Father Fuzzy is offline
MVP
 
Join Date: Jan 2012
Location: B.C.
Posts: 474

My System Specs

Default

Quote:
Originally Posted by Mnpctech View Post
Good to hear, next time you order, give me heads up, I'll toss in a sample of something.

and Keep these awesome updates rollin in
I will for sure
Quote:
Originally Posted by Overclocking.ca View Post
Did you have to do any modification to the water block's backplate to fit on that board?
I was about to cut it then I used extra washers to get off that chip/block thang
and was extra carefull about that turning into xtra pressure on the chip

Quote:
Originally Posted by Prolab View Post
Where did you get those QDC for the CPU block?

Ive been looking for awhile to get those.
I got them at ncix and a few from dazmode I have a ton of them in my 44 Magnum rig
so I can swap out motherboard tray which I hope to try soon

It was just too tight in the prodigy with the qdc's and 3/4 Tubing and fittings onhand also fiqured I wouldn't be swapping it out much only itx board I have

A 200 mm rad would fit nice in this Case and keep the 5.25 drivebay
Reply With Quote