April 5, 2012, 03:10 PM
|
 | MVP | | Join Date: Nov 2010
Posts: 353
| |
 Try using ATTO and/or Crystal Disk Mark 3
Two things:
1. Can you check in your BIOS that your SATA3 is "Enabled" - same section and page
OnChip SATA3.0 Support
Enables or disables the SATA 6Gb/s function integrated in the Chipset. When set to Disabled, the SATA controller will operate in SATA 3Gb/s mode. (Default: Enabled)
2. Could you run additional SSD tests using ATTO or Crystal Disk Mark 3, and see if they give you the same results? [Edit: You are using AS SSD to do the test, and that is a punishing software; I am sure you will see better numbers using ATTO and/or Crystal Disk Mark.]
Last edited by EmptyMellon; April 5, 2012 at 05:16 PM.
Reason: Removed point 3.
|