View Single Post
  #1 (permalink)  
Old March 10, 2012, 04:41 PM
Kylek57 Kylek57 is offline
Banned
 
Join Date: May 2010
Posts: 11
Talking Custom reservoirs

Hello fellow Canucks.

This is my attempt to create a unique reservoir. Some of you may have already seen this, but to those of you who have not. Enjoy.

This was the first finished prototype.




Nothing special at all. Acrylic measures 74mm and the top cap measures 40mm and bottom 51mm. Total length is 165mm. 1 inlet, 1 outlet, and one fill point.

Now their were other prototype caps, but were complete failures IMHO and were discarded immediately.

Now these are two finished, final versions of my design. They are flawless, but are covered in finger prints. :p





Dimensions and features are identical to the prototype. These however have a much better fit/finish.

This is them in my current build.




What do you guys think?
Reply With Quote