Thread: Cutting tubing
View Single Post
  #2 (permalink)  
Old June 1, 2008, 09:45 AM
enaberif's Avatar
enaberif enaberif is offline
Hall Of Fame
Join Date: Dec 2006
Location: Calgahree, AB
Posts: 11,268

Originally Posted by elninio View Post
I'm not trolling... but I would like to know if there is a trick to getting 90 degree cuts on tubing. It always seems I'm cutting the tube perpendicular to the tube length but close inspection reveals a 30 degree cut.. Is there a simple trick to get these 90 degree cuts? I'm talking about the plastic tubing, non-metal.
cut like always then get a sharp knife to trim to make it flat
Reply With Quote