[encorp]

Bump!

I figured it all out now, got the 1:1 thing down pat.

I've been working on it all morning, cannot seem to get it to run stable for more than 30 minutes on any voltage below vcore 1.45

I havn't touched the FSB voltages yet as I'm still sort of figuring everything out.

So far 9x multi @333 for 3ghz vcore 1.4**** still not stable.

It's the same core failing each time, 90% of the time it's core 2 and the other 10% it's core 1. Core's 3/4 have not failed on any tests on any voltage so far ( dosn't mean they won't, just not before the first two do)

core's 1/2 seem to run about 3°-5° hotter on all occasions from idle to full load.

Could this be inconsistent cpu goop or a possibly uneven heatspreader/heatsink base? Or should I even worry about it since my temps are never over 51° (after an hour or two they seem to settle at about 45-49 accross all four) but I'm worried about pushing my vcore anymore, cause nothings been stable so far.. in fact; I'm not trying to push it so i'll back off my clock to 2.8 if need be, to keep my vcores as far away from 1.5 as possible.

my memory is in 1:1 at 666.7mhz/2=333 of course so no issues there. Is it worth going asynchronous for this or not or should I keep pushing synch mode?

Also; I couldn't find my PCI/PCIE frequencies in the bios; should I worry about these busses increasing with my oc?

Replies would greatly be appreciated!