tri-fire loop, filling/bleeding
View Single Post
May 18, 2008, 05:44 PM
Join Date: Feb 2008
Well its all filled now, took about 2 hours to get rid of bubbles. It was rather annoying, the bubbles would come towards the T-line and most of them go right past it into the pump again for another round. The second res on the back seemed to help, I would send the bubbles into the back rad, then open the top for a second, some water would leak out but with it the air got out too.
I have a really small leak at the outlet of the front rad, I dont get why its leaking, I replaced the fitting and tightened it plenty, for some reason it just has a really slow drip.
I'm going to let it run like this until tomorrow, if its all dry then I'll hook up the motherboard ;)
Thanks for the tips!
AMD PHENOM X3 720
2X 2GB @ 1066
VIDEO: 3 x
My System Specs
View Public Profile
Send a private message to vinister
Find all posts by vinister