Not the best pics in the world, but my wife's watching a movie so I can't retake them right now......
This is the original Cosmos 1000.
The center arrow is the locking bar which is tight up against the case side so you can't pass wires over it or they will be crushed.
The top and bottom arrow show the "choke points" when it comes to managing wires on the back of the case.
The bottom one isn't too bad as there is room on the "inside" of the case side which is filled with sound deadening foam.... the top one however is also tight against the case side, so no wires can be passed over it.
Not exactly the best design.
Here's the backside of the Cosmos S.
As you can see, both the upper and lower "choke points" are gone!!!!
There is a minimum of 3/8" clearance now to the case side, and even more in the center part of the case side (no foam any more either).
There is also now a channel which runs behind the main locking bar.
Kinda hard to see the channel in this pic, but I can fit my index finger through it (wide enough for a molex as well) and can't get my thumb into it.
__________________
ASUS SaberTooth 990FX / AMD 1090T / 2X4 Gig Gskill RJ X / XFX Pro 1000W PSU / 2X MSI 560GTX-Ti Twin Frozr II / Corsair F120 / WD 6401AALS
TT Lvl 10 GT / DDCPX-Pro / EK XT 240 Rad / 2X Scythe Ultra Kaze / EK Supreme HF / XSPC 250mm Res / Dell Ultrasharp 2209WA
Asus CH IV / Athlon II X2 250 / 4X2 Gig GSkill Pi PC3-12800 / 2X GTS 450 / PC P&C 750W Silencer / PA 120.2 /
MCR220-QP-Res / Swiftech MCP350 Pump / XSPC Laing DDC top / EK-Supreme HF / Lian-Li Pitstop T60 / Samsung 931BF